Juniper Networks NETSCREEN-5GT ADSL Guide De L'utilisateur page 21

To configure the user name "roswell" and password "area51" for PPPoE and bind the
PPPoE configuration to the adsl1 interface:
WebUI
Network > PPPoE > New: Enter the following, and then click OK:
PPPoE Instance: poe1
Bound to Interface: adsl1 (select)
Username: roswell
Password: area51
CLI
set pppoe name poe1 username roswell password area51
set pppoe name poe1 interface adsl1
save
There are other PPPoE or PPPoA parameters that you can configure on the NetScreen
device, including method of authentication (by default, the NetScreen device supports
either Challenge Handshake Authentication Protocol or Password Authentication
Protocol), idle timeout (default is 30 minutes), and so on. Ask your service provider if
there are additional PPPoE or PPPoA parameters that you need to configure to enable
proper communications with the service provider's server.
Static IP Address and Netmask (Optional)
If your ISP gave you a specific, fixed IP address and netmask for your network, configure
the IP address and netmask for the network and the IP address of the router port
connected to the NetScreen device. You need to also specify that the device use the static
IP address. (By default, the NetScreen device acts as a PPPoE or PPPoA client and
receives an IP address for the ADSL interface through negotiations with the PPPoE or
PPPoA server.)
To configure the static IP address 1.1.1.1/24 for the network:
WebUI
Network > Interfaces > Edit (for the adsl1 interface): Enter the following, and then
click Apply:
IP Address/Netmask: 1.1.1.1/24
Static IP: (select)
Note: You need to configure a PPPoE or PPPoA instance and bind it to the adsl1
interface, as described in the previous section. Make sure that you select "Obtain IP
using PPPoE" or "Obtain IP using PPPoA" and the name of the PPPoE or PPPoA
instance.
NetScreen-5GT ADSL
Required Configuration
17