Dacor DTI30M Serie Instructions D'installation page 13

Before you make the electrical connection:
To properly install your cooktop, you must determine the type of electrical connection you
will be using and follow the instructions provided for it here.
• A 3-wire or 4-wire, single phase, 208 or 240 volt AC, 60-Hz, power supply is required
on a dedicated double pole circuit breaker of at least 40 amps for the 30" cooktop, and
of at least 45 amps for the 36" cooktop.
NOTE
• The cooktop is rated 240 volt. Some models have a neutral (white) wire.
• The cooktop should be connected directly to the junction box through flexible, armored
or nonmetallic sheathed, copper cable. The flexible, armored cable extending from the
fuse box or circuit breaker box should be connected directly to the junction box.
• Locate the junction box to allow as much slack as possible between the junction box
and the cooktop so that the cooktop can be moved if servicing becomes necessarry in
the future.
• Do not cut the conduit. Use the length of conduit provided.
• A UL listed or CSA approved conduit connector is necessary at each end of the power
supply cable (at the cooktop and at the junction box). A listed conduit connector is
already provided at the cooktop.
• If the house has aluminum wiring, follow the procedure below:
1. Connect a section of solid copper wire to the pigtail leads.
2. Connect the aluminum wiring to the added section of copper wire using special
connectors and/or tools designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's recommended procedure. Aluminum/
copper connection must conform with local codes and industry accepted wiring
practices.
NZ9500K_MOD_DTI30M977B_DG68-00898A-00_EN+MES+CFR.indb 13
English 13
2017-04-05 3:02:29