Philips AT940 Mode D'emploi page 22

ENGLISH
22
Problem
The shaver does
not shave as well
as it used to.
The shaver does
not work when I
press the on/off
button.
The shaver does
not work, although
it is connected to
the mains.
Possible cause
The shaving
heads are
damaged or
worn.
Foam or gel
residues clog
up the shaving
heads.
Long hairs
obstruct the
shaving heads.
You have not
inserted the
shaving heads
properly.
The
rechargeable
battery is empty.
The temperature
of the shaver is
too high. In this
case, the shaver
does not work.
This shaver is
not designed to
be used directly
from the mains.
Solution
Replace the shaving heads
(see chapter 'Replacement').
Rinse the shaving unit under a
hot tap (see section 'Cleaning
the shaving unit under the
tap' in chapter 'Cleaning and
maintenance').
Clean the shaving heads one by
one (see section 'Cleaning the
shaving unit with the cleaning
brush' in chapter 'Cleaning and
maintenance').
Make sure that the projections
of the shaving heads fit exactly
into the recesses (see section
'Cleaning and maintenance').
Recharge the battery
(see chapter 'Charging').
As soon as the temperature
of the shaver has dropped
sufficiently, you can switch on
the shaver again.
Recharge the battery
(see chapter 'Charging') and
disconnect it from the mains.