Hazardous Locations; Explosion Hazard - Rockwell Automation Allen-Bradley PanelView 300 Instructions D'installation

Hazardous Locations

This equipment is suitable for use in Class 1, Division 2, Groups A, B, C, D or
non-hazardous locations only. The following DANGER statement applies to use
in hazardous locations.
DANGER
!
Use only the following communication cables in Class 1, Division 2, Hazardous
Locations.
Environmental Classification
Class I, Division 2, Hazardous Locations

Explosion Hazard

• Substitution of components may impair suitability for Class
I, Division 2.
• Do not disconnect equipment unless power has been
switched off and area is known to be non-hazardous.
• Do not connect or disconnect components unless power has
been switched off.
• All wiring must comply with N.E.C. article 501-4(b).
• Peripheral equipment must be suitable for the location it is
used in.
PanelView 300 Micro Terminal
Communication Cable
1761-CBL-PM01, Series C
1761-CBL-HM02, Series C
1761-CBL-AM00, Series C
1761-CBL-AP00, Series C
2711-CBL-PM05, Series C
2711-CBL-HM05, Series C
2711-CBL-PM10, Series C
2711-CBL-HM10, Series C
5
41061-156-01(A)