Type Of Installation - Ultraflex UC 69-1 Manuel D'installation Et D'entretien

ULTRAFLEX
CAUTION
An excessive hose bend could result in its internal breaking which
will cause a bad operation of the system. In this case it is necessary to
replace the damaged hose.
Connect the hoses (1) not supplied to the cylinder connections (2)
with a torque of 20[Nm] (15[lb ft]).according to the following
instructions:
- minimum hose bend radius 250 mm;
- no interference with the transom;
NOTICE
IThe installation of the tubes (cutting, bending and routing) must be
carried out by specialized staff by following the instructions of the
manufacturer.

3.4 Type of installation

NOTICE
With reference to the boat, the hose which is connected to the port side (P) of the pump must be always
connected to the fitting of the side port (P), while the hose which is connected to the starboard side (S) of the
pump must be connected to the fitting of the starboard side (S),
WARNING
Connect hoses as shown in the following pictures:
The UC 69-I (only single station and single helm), UC 116-I, UC 168-I, UC 215-I and UC 293-I hydraulic
cylinders for inboard engines can be installed with different configurations according to the number
and the type of engines used with a single or dual steering system. The possible configurations are:
SINGLE STATION / SINGLE CYLINDER:
S
l
1
l
S
P
ULTRAFLEX
PUMP
1. steering station
2. cylinder
3. T fittings with bleed valves
4. Kit OB
3
P
l
l
2
l
l
4
HYDRAULIC CYLINDERS FOR INBOARD ENGINES
Installation and Maintenance Manual
SINGLE STATION / SINGLE CYLINDER
WITH DUAL HELM:
S
P
1
l
1. steering station
2. cylinder
3. T fittings with bleed valves
4. Kit OB
5. tie bar
NO
2
1
5
3
S
l
l
P
l
l
2
l
4
l
page 13
- of 71