Ultraflex UC 69-1 Manuel D'installation Et D'entretien page 11

ULTRAFLEX
3 Check if the "z" axis of the bracket (1) is
perpendicular to the"x" axis of the cylinder. Fix
the bracket (1) on a proper support using through
bolting M6 (UC 69-I) or M8 (UC 116-I, 168-I, 215-I,
293-I) (screws and nuts not supplied) made of
stainless steel of class A2-70 (ISO 3506-1) or a
higher one and fasten them by means of stainless
steel self-locking nuts with the same mechanical
and corrosion resistance and the corresponding
washers with a tightening torque of 10 Nm using
a 10 mm wrench (for bolt and nut M6 UC 69-I) or
of 25 Nm with a 13 mm wrench (for bolt and nut
M8 UC 116-I, 168-I, 215-I, 293-I).
NOTICE
The oil fittings must be always in high position.
4 Connect the joint (3) to the arm (2) keeping into account the hole diameter: the arm must be under
the joint; (follow the instructions of the arm manufacturer).
NOTICE
The bolt (6) must be made of material suitable for the resistance to the saline mist
and for the maximum thrust indicated in the table of paragraph 1.4; the safety washer
(5) must comply with the dimensions as prescribed by standard ABYC P21.
Connection to the
motor arm as prescribed
by standard ABYC P21.
6
3
2
l
HYDRAULIC CYLINDERS FOR INBOARD ENGINES
Installation and Maintenance Manual
D*
x
z
* see table in par. 1.4
Bolts
UC 69-I
UC 116-I
UC 168-I
UC 215-I
UC 293-I
l
5
l
4
l
l
E*
l
1
Minimum class
M6 A2-70
M8 A2-70
M8 A2-70
M8 A2-70
M8 A2-70
page 11
- of 71