Maintenance And Troubleshooting - Wine Cell'R WC-45 Manuel De L'utilisateur

6
7. Cautions
• When using wine cellar for the first time or after it has been moved, wait for
24 hours before plugging it in to avoid damage to the compressor.
• after removing the power plug from the outlet, wait 5 minutes before plugging
the wine cellar in again to avoid damaging the compressor.
• if there seems to be a temperature sensor failure, please reset the wine cellar:
turn it on for 5 minutes, turn it off for 20 minutes and turn it back on. to prevent
accidents, do not use it on an overloaded circuit or outlet. the electrical outlet
should have proper ground fault protection.
• do not place weight on the electrical cord. Please contact a qualified electrician
to have the power cord replaced in accordance with applicable electrical codes.
• remove all packing prior to using the wine cellar to ensure its proper operation.
• explosive containers or hazardous chemicals cannot be stored in the wine cellar
under any circumstances.
• Be careful not to pour water or other liquids on the wine cellar. moisture on the
electrical wires or components could cause result in an electrical hazard, short
circuit or other malfunctions.
• internal wine cellar temperature fluctuations are normal.
• do not put excessive weight on the wine cellar or on its door. this might affect its
stability and make it topple over.

8. maintenanCe and trouBlesHootinG

• if the wine cooler does not get cold at all: Check to ensure the power plug is
installed properly.
• if the wine cooler does not get cold enough: is the temperature set too high?
is the door being opened and closed too frequently? Has the interior light been
on for extended period?
• if the wine cooler seems to be noisy: make sure it is properly leveled and standing
up firmly. You may have to adjust the leveling legs. also check to see if there may
be another source of noise nearby as this might be the noise source.
05m1_manuel_WC-45_11477.indd 6 17/08/11 4:03 PM