Wine Shelf Removal And Installation; Instructions For Correct And Efficient Use - Wine Cell'R WC-45 Manuel De L'utilisateur

4

4. Wine sHelF removal and installation

1. remove any bottles stored on the racks.
2. Pull out the racks and press the black tongues on each side. (see figure 1)
to put back the shelves in place
Push the racks into the sliders all the way to the back of the wine cellar. if inserted
correctly, the tongues will prevent the shelves from being pulled out completely by
accident. (see figure 2)
NOTE: the bottom rack cannot be removed. (see figure 3)

5. instruCtions For CorreCt and eFFiCient use

• on the control panel, you will find two led displays: the right display shows
the temperature for the upper (white wine) zone and the left display shows the
temperature for the lower (red wine) zone. When the cabinet temperature is too
low the led display will show "ll". When the temperature is too high it will display
"HH". the "er" display shows when there has been a power disruption.
• the two temperature zones ensure the proper storage temperature for the right wine.
You can adjust the temperature of your red and white wine separately. red wines
are usually stored in the lower three shelves of the cabinet. the temperature for red
wines can be adjusted from 55°F-65°F (13°C-18°C). the red wines temperature
already pre-set is 55°F (13°C). White wines are stored in the upper three shelves
05m1_manuel_WC-45_11477.indd 4 17/08/11 4:02 PM