Thermador T18BD Serie Guide D'utilisation Et D'entretien page 22

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fault
Ice cubes have an unpleasant odor/
flavor.
Ice maker is not producing any ice. The ice cube container is in the false
The ice maker is not producing
enough ice or the ice cubes
are misshapen.
Ice is forming in the supply hose
to the ice maker.
Condensation forms on the
dispenser unit.
Water is flowing out of the
 Close shut-off valve
appliance.
immediately.
22
Possible cause
Ice which is stored for a long time may
absorb odors which impair their taste.
The ice cube container is dirty.
Unsealed packages in the freezer transfer
odor/flavor particles to the ice cubes.
Clean the inside of the appliance.
position.
The water pressure is too low.
The freezer compartment temperature
is too high.
A wrong water valve has been installed.
The manufacturer is not liable for damage to property due to an incorrect installation
or water connection.
The water pressure is too low.
The freezer compartment temperature is too
low.
Change the water filter.
The water pressure is too low.
The freezer compartment temperature
is too low.
The ice maker is switched off (see
"Switching off the ice maker"). The
condensation heater does not function.
The water pipe in the appliance is defective. Call customer service immediately.
The water pressure is too low.
A wrong water valve has been installed.
The manufacturer is not liable for damage to property due to an incorrect installation
or water connection.
Remedial action
Dispose of old ice cubes. Use the ice maker more
frequently.
Empty and wash out the ice cube container.
Check whether the frozen food has been packed
in airtight containers.
See section on "Odors".
Reinsert the container and slide it backwards
to the end position (see section "Variable interior
design").
Check water pressure. The water pressure must
be between 25 and 120 p.s.i. (1.72–8.25 bar).
Check temperature of the freezer compartment.
If required, lower the temperature.
3
Self-tapping valves and
/
16
saddle valves reduce the water pressure and may
eventually block the pipe.
Check water pressure. The water pressure must
be between 25 and 120 p.s.i. (1.72–8.25 bar).
Check temperature of the freezer compartment.
If required increase the temperature.
Instructions for changing the water filter can be
found in the enclosed installation instructions.
Check water pressure. The water pressure must
be between 25 and 120 p.s.i. (1.72–8.25 bar).
Check temperature of the freezer compartment.
If required increase the temperature.
You have to activate the condensation heater.
Switch on the ice maker.
Simultaneously hold down the LOCK OUT
and the AGITATION buttons for 3 seconds.
The WATER light and the ICE CUBE light
flash twice.
The ice maker is switch off and the
condensation heater works.
To re-activate the condensation heater:
Simultaneously hold down the LOCK OUT
and the AGITATION buttons for 3 seconds.
The WATER light and the ICE CUBE light
flash once.
The valve may leak if the water pressure is too
low. The water pressure must be between 25 and
120 p.s.i. (1.72–8.25 bar).
3
Self-tapping valves and
/
16
saddle valves reduce the water pressure and may
eventually block the pipe.
inch (4.76 mm)
inch (4.76 mm)

Publicité

Table des Matières
loading

Table des Matières