CERTIFIED 060-0582-0 Guide D'utilisation page 24

2. Loosen the middle two sets of nuts and
bolts to detach the worn rubber plate from
the metal frame (Fig. 23).
3. Attach the new rubber plate onto the
metal frame by replacing and tightening the
middle two sets of nuts and bolts (Fig. 23).
4. Reassemble the rubber plate assembly to the auger assembly by replacing and tightening the
two sets of nuts and bolts used to secure it (Figs. 21 & 22).
Replacing the Scraper Bar
1. The scraper bar is located at the base of
the snowblower beneath the rotor housing
(Fig. 24).
2. Detach the worn scraper bar from the
snowblower by removing the two screws
that hold it in place (Fig. 25).
23
Fig. 23
Metal frame
Rubber plate
Fig. 24
Fig. 25