Maintenance - CERTIFIED 060-0582-0 Guide D'utilisation

22
model no. 060-0582-0

Maintenance

WARNING
Make sure to turn off the switch and disconnect the extension cord before performing any
maintenance task on your snowblower.
Lifetime Lubrication (Motor and Paddle)
Lubrication is not necessary and may damage the unit. The snowblower is lubricated for lifetime use
at the factory before shipment.
General Maintenance Tips
1. Do not attempt to repair the machine unless you have the proper tools and instructions for
disassembly and repair of the machine.
2. Check bolts and screws at frequent intervals for proper tightness to ensure that the equipment
is in safe working condition.
3. After each snow removal session, run the snowblower for a few minutes to prevent the
collector/impeller from freezing. Shut off the motor, wait for all revolving parts to stop
completely, and wipe residual ice and snow off the unit. Rotate the chute crank several times
to remove any excess snow.
Replacing the Rubber Plates
NOTE: When replacing worn rubber plates, pay close attention to carefully distinguish between the
coarse and smooth side of the plates. Place the coarse side inside and the smooth side outside.
1. Detach the worn rubber plate assembly by
removing the assembly (Figs. 21 & 22).
I contact us: 1-844-428-7277
Rubber plate assembly
Auger assembly
Rubber plate assembly
Auger assembly
Fig. 21
Fig. 22