Elias Px Accessories; Troubleshooting - HK Audio ELIAS PX Mode D'emploi

3 ELIAS PX delivers optimum sound, so you should
provide it with optimum input signals! Noise such as
humming is generally caused by defective cables, the
wrong type of cords, or unbalanced signals routed
into the mixing console. Check all signal and mains
cables.
4 Prevent distortion! Not only is it unpleasant to
your audience's ears, it can also damage your equip-
ment. Make sure all components that are connected
directly and indirectly to ELIAS PX have sufficient
power ratings, and that they don't distort as a result
of operating at or beyond their respective limits.
Provide an undistorted signal to the system in the
first place, so that it doesn't have to be cleaned up
by backing off the system's Gain knob.
5 Avoid ground loops! A ground loop can occur when
the mixer and ELIAS PX are each connected to two
different mains circuits. To prevent this problem,
always connect the ELIAS PX system and the mixing
console to the same electrical circuit (same phase!).
If your equipment hums despite this precaution, the
Ground Lift switch can be a great help.
CAUTION: Never tape over the plug's ground
terminal - this endangers lives!

6 ELIAS PX Accessories

HK AUDIO Tilt-Unit
Designed to hold the ELIAS PX mid/high unit, the
tilt unit is placed on the subwoofer, with the Duo-
Tilt™ fitting offering a choice of 7.5° or 15 ° angles.
HK AUDIO Dust Covers for ELIAS PX
This set comprises subwoofer and satellite covers.
Extremely tear resistant, water repellant and thickly
padded, these covers afford lasting protection for the
ELIAS PX system during transport.
To learn more about original HK AUDIO accessories,
talk to your HK AUDIO dealer or visit
www.hkaudio.com.

7 Troubleshooting

The Power On LED does not light up when switched
on.
1 Check if the power cord is plugged into the Mains
Input.
2 Check if the mains power supply is providing
current.
3 Check if the house circuit breaker has tripped.
The Power On LED lights up red, but no sound is
coming from the cabinets.
1 Check the cords connected to the inputs.
2 Check if the signal sources (mixer, keyboard, CD
player, etc.) are on.
3 Check if the Gain knobs are turned up.
The subwoofer's low frequency output is weak.
1 Check the Subwoofer Gain knob's setting
The signal sounds distorted.
1 Check the LED displays on your mixer. Ensure they
are not constantly in the red. If necessary, back off
the volume at the mixer.
2 If the LED displays on your mixer are in the green,
turn ELIAS PX's Gain knobs to reduce the input
level.
Annoying hum
1 Check the cords connecting the signal source to
ELIAS PX. Replace damaged cords.
2 If you cannot pinpoint the cause of the hum, press
the Ground Lift switch. This should remedy the
problem in most cases.
10
2
3
4
5
6
10
8
7
9
11
ELIAS EPX 115 Sub A controls
9