Henco M-BMINI3 Manuel D'instructions page 26

A
Caution: When the power pack is not being used keep it away from paper
clips, coins, keys, nails, screws and other small metal objects which could act
as contact bridges. A short circuit between the battery contacts could cause
combustion or fi res.
A
Caution: Do not charge the power pack in the presence of easily infl am-
mable gas or materials. After charging, remove the battery charger plug
from the wall socket. Do not disassemble the battery charger.
A
Caution: If the power packs are stored for long periods of time, their char-
ge status must be checked periodically. Th e optimum charge is between
50% and 80%. Th e power packs should be recharged every 12 months at
most to avoid complete discharge which could cause damage.
A
Caution: Discharged power packs should not be stored for periods of more
than one month to avoid their complete depletion which could destroy
the battery.
A
Caution: Use only the battery charger advised by the manufacturer. Th e
use of a battery charger suitable for a specifi c type of battery to recharge
other batteries are a cause of danger of fi re.
A
Caution: Use only the batteries foreseen for the purpose in the tools. Th e
use of other batteries could cause injury and the danger of fi re.
A
Caution: In case of incorrect usage liquid could leak from the battery.
Avoid contact with the liquid. In case of contact with the skin wash with
abundant water. Consult a physician if the liquid comes into contact with
your eyes. Liquid that has leaked from the battery may cause irritation to
the skin or burns.
indicates a maximum power reserve of 10%. Th e purpose of this indication is
only to determine whether there is a reserve of power and how much power
the battery still has available.
26
Th e charge status can be read by pressing the relative
button on the power pack. While doing so the battery may
remain in the crimping tool which must be shut off before-
hand, however, and remain shut off for at least one minute
(otherwise the reading will be imprecise). Th e number of
illuminated LEDs indicates the charge status. A fl ashing LED
M-BMINI3