Henco M-BMINI3 Manuel D'instructions page 24

A
Caution: Inspect the battery powered tool to make sure it has not been
damaged. Place the machine in service only if it is free of defects!
A
Caution: If situations of danger for persons or for the machine occur du-
ring operation, stop the press tool by pressing the return button.
A
Caution: The battery powered tool is not suitable for continuous operation.
A
Caution: Accessing the danger zone of the pressing tool is only permissible
when the tool is completely opened and the battery removed.
A
Caution: Inspect the area of danger before turning the tool on. Only start
the tool if no hazards result from it and if no person is in the danger zone
of the pressing tool.
A
Caution: The battery may be removed when the hydraulic battery powe-
red press tool has been shut down safely.
A
Caution: During work performed at heights the tool must be adequately
protected from falling.
A
Caution: Before using the equipment, it is necessary to perform a visual
inspection to ascertain the condition of the battery powered press tool.
The equipment may not be used if it has been damaged.
A
Caution: Reverse movement is activated exclusively with the relative key.
The mechanical release lever located on the equipment must be used in
emergency situations.
A
Caution: Do not open the machine! All guarantee rights are forfeited if the
seal is damaged. The equipment must not be operated without protective
covering.
A
Caution: If the service light turns on the machine must be sent to the
service-center. The customer is not authorised to perform maintenance,
as this would entail loss of guarantee and can cause situation of danger.
Caution: The typical A-weighted noise level can exceed 70dB (A) during the
working process. - wear ear protection!
A
Caution: The equipment may be operated only with the original power
packs.
24
M-BMINI3