Black & Decker EASYCUT EC500 Guide D'utilisation Et D'entretien page 4

HOW TO USE CAN OPENER
1
Slip the post on the cutting
assembly into the hole on the
upper left corner of the front
of the base.
5
Remove the can by holding it
with one hand and lifting the
lever with the other.
2
Plug power cord into outlet.
NOTES:
• This can opener will not open rimless cans or cans with angled corners and should not
be used to open cans with a peel-off foil or rolling key.
• Frozen juices or foods in cardboard cans should be opened as soon as they are
removed from the freezer. Aluminum lids will not stick to the magnet.
• It is not necessary to hold the lever down or support the can during cutting.
However, you may have to hold the base when cutting very tall or very heavy cans.
CAUTION:
• Avoid contact with the cut edges of the can or lids; they are sharp. Carefully remove
the lid from the magnet and discard.
3
Lift lever up. Tip the can
so that the rim is under the
locating post. Make sure that
the cutter is inside the rim
of the can.
4
4
Push down on the lever.