Access Control Description; Access Control Programming; Programming Methodes - golmar Stadio Plus T4003ML Manuel D'installation

45
Jumper JP4, that's placed on the left side of the terminal connector
allows to reset the installer PIN code to the factory default
(see page 46).
Use this function only in case to forget this code.
With the system switched on, change the jumper position
to reset the code and return it to the standby position.
It will be necessary to enter into the programming menu to configure the system properties.
Two different programming menues are available: installer, that allows to modifiy any of the
system properties and user, that only allows to change the relay activation codes,
the user code and to disable the keypad acknowledgement signal.
Programming options with black text and white background are availables in both menues;
options with white text and black background are only availables on installer menu.
The module will automatically exit from the configuration menu after 2 minutes with no operation.

ACCESS CONTROL DESCRIPTION

Installation terminal connector is located on the rear
part of the module. The correspondance of each
terminal is as follows:

ACCESS CONTROL PROGRAMMING

M
~, ~ : power supply input.
B+ : positif for battery.
B– : negatif for battery.
C1 : relay 1 common terminal.
N1 : relay 1 output terminal.
NC2 : relay 2 normally closed output.
C2 : relay 2 common terminal.
NA2 : relay 2 normally closed output.
P : panic output.
Reset.
P
rogramming methodes.
odule description
Standby.