IntesisHome PA-RC2-WIFI-1 Guide D'installation page 5

IntesisHome PA-RC2-WIFI-1
®
7. Close the IntesisHome's and Panasonic's lid again.
8. Plug the Panasonic system to mains electricity.
If connection with the Panasonic system has been successful, IntesisHome device LED will start
blinking Green and then will change to steady Green.
9. Connect the external antenna into the antenna connector.
10. Place the antenna preferably in a vertical position and pointing directly to the Wi-Fi Router or
Access Point (AP). See section 3.
2.2 Without Control Panel
This method assumes that you want to control the Panasonic system through IntesisHome
exclusively.
1. Unplug the Panasonic system from mains electricity.
2. Open the top lid of the IntesisHome device.
3. Remove IntesisHome's Top Hole cover.
4. Connect one end of Panasonic's bus cable into IntesisHome device K1 connector.
5. Connect the other end of Panasonic's bus cable into Panasonic's Indoor Unit R1R2 connector or
Remote Control Wiring (see www.intesishome.com/docs/PA-RC2-WIFI-1-Install_sketch.pdf for
more information).
6. Close IntesisHome's lid again.
7. Plug the Panasonic system to mains electricity.
If connection with the Panasonic system has been successful, IntesisHome device LED will start
blinking Green and then will change to steady Green.
8. Connect the external antenna into the antenna connector.
9. Place the antenna preferably in a vertical position and pointing directly to the Wi-Fi Router or
Access Point (AP). See section 3.
K1
3 m
Max. 500 m
Wi-Fi Router or
Access Point
R1
R2
INSTALLATION GUIDE
EN
5