Important; Disconnecting Your Dishwasher - Farberware FCD06ASWWHC Manuel D'utilisation

1. Screw the faucet adapter onto (or into) the faucet tap. Check
for leaks (use Teflon tape to eliminate if necessary).
2. Connect the six-sided connection of the drain hose to the drain port connection on
the back of the dishwasher cabinet. Do not over-tighten (to avoid damage to threads).
3. Connect the star-shaped connection of the inlet hose to the inlet port on the back
of the dishwasher cabinet. Do not over-tighten (to avoid damage to threads).
4. Connect the circular connection of the drain hose onto the
longer (bottom) male connection on the quick connect.
5. Connect the circular connection of the inlet hose onto the
shorter (top) male connection on the quick connect.
6. Attach the quick connect onto the faucet adapter, by pulling down
the outer locking collar on the quick connect, while pushing
the quick connect upward onto the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release
the locking collar. Verify the connection is secure.
8. Slowly open the hot water line and check for any sign of water
leaks at all hose connections. If leaks are located, immediately
close the water supply and repair the hose connections.

Important

• Once you open the water supply line, (even if it is closed
immediately thereafter), the inlet hose will be pressurized.
• To relieve water pressure from inside the inlet hose, (make sure the
water line (faucet) is closed): press and hold the red pressure relief
button on the quick connect until the flow of water stops.
WARNING: FAILURE TO RELIEVE WATER PRESSURE, BEFORE DISCONNECTING
THE QUICK-CONNECT FROM THE FAUCET, WILL RESULT IN BACK-PRESSURE OVER-
SPRAY. THE TEMPERATURE OF INCOMINGWATER CAN BE VERY HOT, AND BACK-
PRESSURE OVER-SPRAY COULD CAUSE SEVERE BURNS AND/OR SCALDING.
DANGER: DO NOT LET CHILDREN DISCONNECT THE DISHWASHER; CLOSE
SUPERVISION OF CHILDREN IS ALWAYS IMPORTANT AROUND APPLIANCES.
NOTE: Hard water conditions will adversely affect the washing performance of your
dishwasher. Hard water conditions will also contribute to 'lime' (white film substance)
deposits and/or 'scaling' on the stainless steel surface of the dishwasher tub and
heater element, located in the sump underneath the removable filter screen. To assist
in minimizing these conditions, it is recommended to periodically operate/rinse the
inside of the dishwasher (empty) using 1 cup of white vinegar at least once a week.

Disconnecting your dishwasher

1. Shut off the water supply at the faucet.
2. Disconnect the power supply cord.
23