Change The Program; Forget To Add A Dish; At The End Of The Wash Cycle - Farberware FCD06ASWWHC Manuel D'utilisation

NOTE: If you open the door when you're washing, the machine will pause. When you
close the door you need to press Start/Cancel button to keep the machine working.

CHANGE THE PROGRAM

Premise: You can modify the washing program, When the dishwasher just runs for
a short time. Otherwise, the detergent may have already been released, and the
appliance may have already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled "Loading the Detergent").
To change the washing program, press the Start/Cancel button to pause the
machine, then press the Start/Cancel button more than three seconds the
machine will be in stand by state, then you can change the program to the
desired cycle setting (see the section entitled " Starting a wash cycle").
The lights show the state of the dishwasher:
a) All phase lights off..............................................On stand by
b) The display no blinking ....................................Being paused
c) The display blinking...........................................Running
NOTE: If you open the door when washing, the machine
will pause. When you close the door, you need to press
start/cancel button to keep the machine working.

FORGET TO ADD A DISH?

A forgotten dish can be added any time before the detergent cup opens.
1. Press the start/cancel button
2. Open the door a little to stop the washing
3. After the spray arms stop working you can open the door completely
4. Add forgotten dishes
5. Close the door
6. Press the start/cancel button. The dishwasher will run after 10 seconds

AT THE END OF THE WASH CYCLE

When the working cycle has finished, the buzzer of dishwasher will sound 8 seconds,
then stop. Turn off the appliance using the power button, shut off the water supply
and open the door of the dishwasher. Wait a few minutes before unloading the
dishwasher to avoid handling the dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better. Since the appliance is standing
by, it will power off automatically after 30 minutes without any operation.
Switch off the dishwasher:
All the phase lights are off. Only in this case the program has ended.
16