Led Light Strips - Zephyr Roma Groove ZRG-E30AS Guide D'utilisation, D'entretien Et D'installation

LED LIGHT STRIPS

In the unlikely event that your LED strip fails, please contact Zephyr to order replacement parts.
See list of parts and accessories page for part #'s and contact information.
To replace LED light strip
1. Remove aluminum mesh filters.
2. Remove light panel by two screws.
3. Disconnect LED light strip quick connector.
4. Push in the two side clips on the ends of the LED strip.
5. Push LED light strip through the light panel opening.
Push the clip
FIG. F
17