emerio FN-111453 Mode D'emploi page 6

ASSEMBLING INSTRUCTIONS
1. Remove all the fan parts from the packaging.
2. Take down the L screw and the washer from the column. Insert the column into the hole on the base. Fasten
the L screw and the washer to fix the column with the base firmly.
3. Loosen the screw from the fan body and attach the fan body on to the column tube.
4. Fix the fan body and the column with the screw.
5. Put the fan on the ground and plug in. Your appliance is ready for use now.
OPERATION INSTRUCTION
1. Plug the power cord into a suitable socket. All LED lights will be shining for 2 seconds with beep sounds. The
fan is under standby mode.
2. Touch the button "
mode, with no timer or oscillation function.
NOTE: This appliance is equipped with a body sensor (see below "About Body Sensor"). After the fan is
switched on, the body sensor will be activated automatically and the fan body will start turning around to
detect user's position. Button "
3. Touch button "
4. Touch button "
appliance will stop working automatically after finishing counting down.
5. When the appliance is under working, you can touch button "
(Body sensor)" or "Vertical oscillation".
1) Horizontal oscillation (Body sensor): Touch button "
with "No horizontal oscillation → 60°→ 90°→ 180°→ 360° → Body detecting → No horizontal
oscillation ...".
About Body Sensor:
a. What is body sensor?
Automatically detect user's position and select the suitable oscillation angle.
" to start the appliance. The appliance is initially set at low wind speed in normal
" can be manually touched to deactivate body sensor function.
" to set your desired wind speed at "Low → Medium → High → Low ...".
" to set your desired working time of "1H → 2H → 4H → 8H → no timer → 1H ..." The
" or "
" to set your desired horizontal oscillation angle
- 5 -
" to set "Horizontal oscillation