Accessories; Service And Repairs - WELDY booster EX2 Notice D'utilisation

Replacement of carbon brushes (drill machine)
Switch off the hot tool and disconnect it
from the mains supply.
1.1

Accessories

• Only WELDY accessories must be used.
• WELDY offers the right welding shoes for different common types of seam:
Blank V Seam
Maintenance
• In case of soiling clean the air inlet on the hot air blower with a brush.
• Clean the extruder nozzle (19)
• Check power supply cord and plug for electrical and mechanical damage.
• Regularly clean the air hose.

Service and Repairs

• Ensure the carbon brushes of the drive and hot air blower checked by your service center after 100 hours
of operation. The drive and the hot air blower switch off automatically once the minimum carbon length
has been reached.
• Repairs should only be carried out by Weldy-partners. Restricted to use with original Weldy accessories
and spare parts.
Warranty
• For this tool, the guarantee or warranty rights granted by the Weldy-partners shall apply. In case of guaran-
tee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
Weldy-partners at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery
document. Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper hand-
ling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
1.2
Fillet Overlap Corner
weld seam
outside
each time the welding shoe is replaced and remove any welding deposits.
1. Unscrew the carbon brush cap.
2. Take out the carbon brush.
3. Put on the new carbon brush and screw cap on.
2
Corner Corner
seam seam seam
short
3.1
long
3.2
16