Dimplex Revillusion RBF24DLX Manuel D'utilisation page 18

Operation
Icon Function
B
Flame
C
Temp Down
Flame
D
Speed
Color
E
Themes
F
360
G
Timer
Light
H
Sensor
I
Brightness
18
Description
Press to light the log set and start the flame effect.
Press again to turn feature Off.
Press multiple times to lower the heater temperature
in 1 F (1
°
lowest temperature is 41
active whenever the heat is enabled.
Press multiple times to toggle through the flame
speeds (minimum, medium, maximum). The display
will show the current speed number, F1, F2 or F3.
Press multiple times to change the flame base colors
from Red to Blue to Off. (The first segment on the
display will change from "r" to "b" to blank) This
feature is active only when the flame effect is On.
Press multiple times to change the LEDs on the sides
and back of the unit from Midnight mode to white to
yellow to red. (The middle segment on the display
Light
o
will change through 0 - 3 respectively. This feature is
active only when the Flame is ON.)
Press multiple times to change the sleeper timer in
0.5 hr increments from 0.5 hr to 8.0 hr before turning
off. The remaining time on the sleep timer displays.
Press to activate the ambient light sensor (ALS ON).
Press again to turn the sensor off (ALS OFF).
!
NOTE: The light sensor will adjust the brightness
of the fireplace based on the ambient light in the
room.
Press to change the LED lights from High to Low.
(The last segment on the display will change from
"H" to "L") The Realog
heater is ON and the flame effect is Off.
!
NOTE: When the Light Sensor is activated, High
and Low flickering brightness settings are also
available (Flashing "H" and "L").
C) increments. Displays current temperature;
°
TM
F (5 C). This feature is
° °
LEDs remain On when the
www.dimplex.com