DEHAS EASYMATE PM2200 Serie Mode D'emploi page 31

8. While holding the Portable System in the fill position,
pull the vent-to-Fill lever to the open position (figure
1). A hissing noise should be noticeable.
NOTE: PM2200 & PM2203, maintain a slight
downward pressure on the Portable System
with one hand to keep the device steady
and maintain proper filling position.
9. Release the vent-to-Fill lever on the Portable System
as soon as you notice a change in the sound of
venting gas followed by a dense, white vapor coming
from the reservoir cover.
NOTE: The maximum time to fill a...
PM 2200 / PM 2202 / PM 2203
PM 2201
If the vent-to-Fill lever fails to close and the hissing continues, remove the Portable from
the reservoir. The Portable will stop venting in a few minutes. The Portable may require
as much as 30 minutes to restore normal operation.
10. Disengagement:
PM2200 / PM2203:
•
Disconnect
from the reservoir by pulling in an upright
motion. Always hold the device with at least
one hand when attempting to disconnect it.
(Figure 2)
PM2201 / PM2202:
•
Disconnect
reservoir by rotating it in counterclockwise
direction until the device separates. The device
may now be removed from the reservoir.
NOTE:
1. It is common to hear a hissing sound after
the Portable System has been filled. This is
the relief
pressure. Upon disengaging the Portable
System from the reservoir it is common to
see condensation
connector.
2. It is common to have a few small droplets
of liquid oxygen coming from the fill
connector when disengaging the Portable
from the reservoir.
the portable
the portable System from the
valve venting
on or near
CAUTION
Figure 2
System
excess gas
the fill
8
30 seconds.
15 seconds.
Figure 1