Table des Matières
Publicité
Anleitung EBH 801 Standard
08.11.2001 7:14 Uhr
GB
Description
1
Locking button
2
Operating switch
3
Rating plate
4
Stop lever
5
Tool chuck
6
Handle
7
Selector button: drill/hammer
8
Power cable
Items supplied
EBH 801
Handle
Dust cap
Technical data
Power per blow:
4.3 J (joule)
Chuck type:
Large spline shaft
Weight:
Sound pressure level:
Sound power level:
108.6 dB(A) LWA
–
Vibration
a
w
Radio suppressed in conformance with
EC Guideline 89/336/EEC
Before you use the hammer drill
Check that the voltage of your power source is the
same as that marked on your hammer drill´s rating
plate. Hammer drills marked with 230 V 50 Hz can
also be operated from a 220 V 50 Hz supply.
General information
The electric hammer drill you have purchased is
designed for use in areas lying beyond the
performance limits of a standard hammer drill. An
ergonomically shaped handle enables safe and
tireless working.
Masonry and
concrete ceilings
pose no problem for this Einhell hammer drill thanks
to its newly developed inductive hammer action
(electromagnetic principle). Special features of this
innovative machine are its compact design and
extremely rugged interior workings. Optimum power
transmission is guaranteed by the large spline shaft.
Thanks to its large range of special accessories the
hammer drill can be put to universal use.
8
Seite 8
Cutting holes through masonry with the selection
of chisel bits supplied
Drilling holes of all types up to a maximum
diameter of 25 mm
Cutting channels in masonry in preparation for
laying cables
Important!
The inductive hammer function is not triggered
until the tool comes up against a counter
pressure. For the hammer action to start, you
must first press the hammer drill with a chisel bit
or drill bit against the masonry, concrete ceiling,
etc.
Safety regulations
Important! To protect yourself from the risk of electric
shock, injury and fire when using an electric tool, it is
imperative to take the following basic safety
precautions. Read and note these instructions
5.9 kg
before you use the machine.
98 dB(A)
Check the voltage (volt) marked on the rating
plate.
4 m/s
2
When using cable drums, run all the cable off the
drum. Minimum conductor cross section: 1.0 mm
When using the electric hammer drill outdoors,
connect to the power supply with a type H07RN-F
3G 1.5 mm
2
extension cable and rain-water-
protected plugs in proper working order.
Make sure of your footing on ladders and
scaffolding when drilling free-handed.
Use a line detector to localize lines in walls with
concealed electric, water or gas lines. Avoid
touching live components or conductors.
Wear ear muffs to protect your hearing. Loss of
hearing can be a gradual process!
Wear goggles and use a dust mask on jobs
generating dust.
Do not use in areas where there are vapours or
flammable liquids.
Always pull the plug out of the socket before
cleaning or making changes to the machine.
Protect the power cable from damage. Oil and
acid can damage the cable.
Never overload the machine.
Secure all workpieces sufficiently.
Important! It is imperative to follow all national
safety regulations concerning installation,
operation and maintenance.
Wear ear muffs to protect your hearing. Loss of
hearing can be a gradual process!
Wear goggles and use a dust mask on jobs
generating dust.
2
.
Publicité
Table des Matières
