Graf 106850 Notice D'installation page 20

13.
-
Push the jack into the sampler (until it snaps into
place).
15.
Insert the jack into the profile for holding the parti-
tion wall from above.
17.
The cord must be secured to the pipe aerator (6
mm hole). The air hose (19 mm) must be con-
nected on the opposite side. Systems for more
than 7 inhabitants have two pipe aerators.
4. Assembling the set-up kit
6 mm hole
Insert the jack into the tank along with the sampler.
Insert the sampler's outflow connection into the
sleeve of the outflow pipe (use lubricant!). The
sleeve connection must be secured with a Spax
screw.
Position the pipe aerator(s) on the bottom of the
tank. It must be slid under the scum board such
that even the first chamber is ventilated. Secure the
cord to the hose using a cable tie.
18 / 44
14.
16.
18.