Kohler Mariposa Serie Guide D'installation Et D'entretien page 8

Air Switch
O-Ring
Inlet
Outlet
O-Ring
4. Relocate and Connect the Pump
Remove all protective packaging from around the whirlpool harness.
Cut only the cable ties supporting the harness attachment nuts.
Remove the plugs from the pump inlet and outlet connections.
Install the supplied O-rings/gaskets into the grooves on the inlet and outlet connector.
Set the pump on the support bracket.
NOTE: The pump should rest on the same subfloor, at the same level as the whirlpool feet. Shim the
pump if necessary on the subfloor, but make sure the rubber isolation feet are in contact with the floor.
The pump should only be high enough to allow water to drain out of the suction line when the whirlpool
is emptied.
Thread the plastic inlet and outlet nuts onto the pump and heater until the O-rings and gaskets
make initial contact.
Securely handtighten each nut, then tighten each nut an additional quarter turn.
Make sure the whirlpool inlet piping is pitched down and away from the pump.
Secure the pump support bracket with four screws or lag bolts (not provided).
Connect the air tubing to the air switch on the pump.
1193347-2-B
Air Tube Inlet
Hole
Pump
8
When installing the pump,
make sure to remove the plugs
from the inlet and outlet piping.
Provide access to the installed pump for servicing.
Relocate the pump.
Kohler Co.