Fault Code - Electrolux EXP09HSECI Manuel D'utilisation

Dry mode
In this mode you do not need to use the
exhaust adaptor hose, BUT the water
collected must be discharged� See 7�3
Drainage Section�
1. Press the "Modes" button until the "Dry"
indicator is lit�
2. The fan will run at low speed and the
display will show the room temperature�
3. Keep doors & windows closed for best
effect�
4. Connected drain hose� See Drainage
section�
Auto mode
Always have the exhaust hose attached in
this mode�
When you set the air conditioner in Auto
mode, it will automatically select cooling,
heating (inapplicable for cooling only
models), or fan only operation depending
on what temperature you have selected
and the room temperature� The air
conditioner will control room temperature
automatically round the temperature point
set by you�
Under AUTO mode, you can not select the
fan speed�
1� Press the "Modes" button until the
"Auto mode" indicator lights�
After the "Auto mode" is selected the unit
will run automatically according to the
actual room air temperature�
Check filter feature
1. Cleaning the filter�
2. Press and hold the "filter" button for 3
seconds to turn off the filter indicator�
Selecting fan speed
You can select the desired fan speed, by
pressing the "Fan speed" button� The fan
speed will change in the sequence: "Auto
Fan", "High", "Mid", "Low"�
After choosing the fan speed as
"Auto Fan", "High", "Mid" or "Low",
the corresponding fan speed
indicator light will illuminate�
Under Auto and Dry mode, you can
not select the fan speed�

7.2 Fault code

If the display reads "A5" , the room
temperature sensor has failed� Contact
your Authorized Electrolux Service Centre�
If the display reads "E5" , the evaporator
temperature sensor has failed� Contact
your Authorized Electrolux Service Centre�
If the display reads "E4" , the display panel
communication has failed� Contact your
Authorized Electrolux Service Centre�
If the display reads "P1" , bottom tray
is full� Carefully move the unit to a drain
location, remove the bottom drain plug
and let the water drain away� Restart the
machine until the "P1" symbol disappears�
If error repeats, call for service�
If the display reads "E7", the indoor
motor has failed� Contact your Authorized
Frigidaire Service Center�
ENGLISH 15