Fault Code - Electrolux EXP09CKEWI Mode D'emploi

How to delay shutdown
You can delay shutdown when the unit is
on�
Press the "timer off" button, the screen
displays " "and "H"�
Tap or hold the UP arrow " " or the
DOWN arrow " " to change delay stop
timer at 0�5 hour increments up to 10
hours, then at 1 hour increments up to 24
hours� After 2 seconds, the setting will be
memorized, and the display will show the
time remaining until the unit shuts down�
To cancel the setting, press the "timer off"
button again�

7.3 Fault code

If the display reads "AS" , the room
temperature sensor has failed� Contact
your Authorized Electrolux Service Centre�
If the display reads "ES" , the evaporator
temperature sensor has failed� Contact
your Authorized Electrolux Service Centre�
If the display reads "P1" , bottom tray
is full� Carefully move the unit to a drain
location, remove the bottom drain plug
and let the water drain away� Restart the
machine until the "P1" symbol disappears�
If error repeats, call for service�
7.4 Drainage instruction
Continuous Drainage
During the DRY mode, you will need a
garden hose (sold separately) to drain the
condensate from the unit�
Follow the steps below:
• Unscrew the drain cap of continuous
drain outlet(Fig�20)�
• Connect one end of the garden hose
(sold separately) to the drain outlet then
lead the other end into a drain that is
lower than the unit(Fig�21)�
NOTE:
• Condensate may flow out after removing
the drain cap, if the unit is running in
Cool or Auto mode� When you want
to remove the garden hose, prepare
a drip tray (not supplied) to collect the
condensate from the drain outlet�
• Please be sure that the height of the
drain and section of the drain hose
should not be higher than that of the
drain outlet, or the continous drainage
may not work properly�
• During Cool or Auto mode, it is
recommended to disable continuous
drainage by replacing the drain cap to
the drain outlet, to reach the maximum
performance
ENGLISH 19
Fig. 20
Drain cap
Garden hose
Fig. 21