Cleaning Prefilter; Replacing The Filter - Anslut 020511 Mode D'emploi

6. Remove the batteries from the product if
it is not going to be used for some time.
7. Do not short-circuit the battery terminals.
FIG. 6
MAINTENANCE
The product requires very little maintenance.
Do not dismantle the product or attempt to
repair it. Service and repairs should be carried
out by an authorised service centre or other
qualified personnel.
1. Switch off the product and pull out the
plug before cleaning and/or installation.
2. Keep the ventilation openings on the back
of the motor unit clean. Do not dismantle
the fan to clean.
3. Wipe the product with a cloth moistened
with water and a mild detergent.
4. Do not use solvent or abrasive detergent,
this can damage the product. Do not
use petrol, solvent or detergent that can
damage the plastic parts.
5. Make sure that no water or any other
liquid gets into the motor unit or control
panel.
CLEANING
1. Switch off the product and pull out the
plug before cleaning.
2. Clean the plastic parts on the product with
a cloth moistened with water and a mild
detergent. Wipe dry with a dry cloth.

REPLACING THE FILTER

1. Filter model: FQ150CJ-2 (2 supplied)
2. The status light goes on when it is time
to replace the filter and the filter icon is
shown on the display. The filter icon is
shown when starting and until the filter is
replaced.
3. Replace filter
4. Press the mode button for 3 seconds to
switch off the status light for replacing
the filter.
FIG. 7

CLEANING PREFILTER

1. Pull out the plug.
2. Take out the filter.
3. Vacuum clean the filter to remove dust.
4. Replace the filter in the product and plug
in the plug.
FIG. 8
EN
25