Other Functions; Remote Control Buttons - Anslut 020511 Mode D'emploi

EN
Button to set fan speed. (Each
time the button is pressed the
setting changes in the order of
1-2-3... 10-1-2).
Button for timing of transition
from active mode to standby
mode, or the reverse.
(Each time the button is
pressed the timing changes
in the order of 0-1-2... 12-0 h).
0 h indicates that the timer is
disabled.
The status light goes on when
it is time to replace the filter.
The status light goes on in fan
mode AI smart. In this mode
the fan speed is automatically
adjusted to changes in the
ambient temperature.
Status light for sleep mode.
The fan speed is adjusted
automatically to the set
programme when sleep mode
is activated. Select level 1, 2 or
3 by pressing the button to set
fan speed.
Fan speed mode or timer
setting on adjustment.
The temperature is shown in fan
mode.
Status light for ionisation mode.
In this mode the ionisation
unit is activated for fan speed
settings 1 to 10.
FIG. 4

OTHER FUNCTIONS

Forced stop
The product switches off automatically after 15
hours if no buttons are pressed.
24
Intelligent memory
If there is a power cut or the product is
switched off it will start again in the same
mode when the power is restored. Timer
settings are not stored.
Automatic fading of display
If no buttons are pressed for 30 seconds the
status light on the casing will go off, but the
fan will continue to run. Press the power switch
to switch off the product when the display goes
off. Press any button to switch on the display.

Remote control buttons

The remote control can be used within 5
metres and at 30° from the front of the
product.
Recycle the remote control battery in
accordance with local regulations.
1. Activation/deactivation of oscillation
2. Press + or - to increase or reduce the
settings for fan speed or timer.
3. Start/standby mode
4. Setting of fan mode
5. Setting of timer for start/stop
FIG. 5
Battery in remote control
1. Push down the battery cover on the back
of the remote control and insert the
batteries.
2. Use manganese or alkaline batteries of
the AAA type. Do not mix old and new
batteries, or different types of batteries.
3. Do not use rechargeable batteries.
4. Insert the batteries with the correct
polarity.
5. Remove used batteries from the product
and recycle in accordance with local
regulations.