Anslut 020511 Mode D'emploi page 23

TECHNICAL DATA
Rated voltage
Safety class
Cord length
Size
Weight
DESCRIPTION
Bladeless tower fan with ten different speeds,
three airflow settings and timer. Comes with air
cleaner function with HEPA filter, control panel
and remote control. The remote control runs
on 2 AAA batteries (sold separately). Spare
filter sold separately.
NOTE:
The figures are only intended for reference.
The actual product may deviate from the
figures and descriptions in these instructions.
1. Top cover
2. Air outlet
3. Display and control panel
4. Middle
5. Base
6. Mains adapter
7. Air inlet grille
8. Prefilter
9. HEPA filter
FIG. 1
Contents
1. 1 remote control
2. 1 copy of operating instructions
3. 2 HEPA filters
4. 1 mains adapter
FIG. 2
230 V ~ 50 Hz
II
1.2 m
W26 x H107 x Ø26 cm
5.8 kg
INSTALLATION
1. Remove the air inlet grille.
2. Remove the prefilter. Press out the raised
parts on each side and remove the
prefilter.
3. Remove the protective film from the filter.
4. Put the HEPA filter in.
5. Replace the prefilter. Fit in the slot in the
bottom and press the U-shaped clip at
the top.
6. Fit the air inlet grille. Align the two top
clips and press in place. Press apart the
sides at the bottom and carefully press the
air inlet grille in place.
7. Connect the mains adapter. Plug the
connector in the base.
8. Plug the plug in a suitable power point.
It is recommended to clean the filter every
other week and to replace it every six months,
depending on usage.
FIG. 3
USE
CONTROL PANEL AND DISPLAY
Button Function
Start/Standby mode
Button to switch between
normal mode, ionisation
mode, sleep mode and AI
smart.
When the status light for
replacing the filter goes on,
press the button to switch off.
Button for starting/stopping
oscillation.
EN
23