Before First Use; Firmware Updates - LaMotte WaterLink Spin Touch DW Mode D'emploi

SETUP

BEFORE FIRST USE

¬ Fully charge battery using the Spin Touch USB cable and adapter plug in AC
outlet.
¬ Ensure your Spin Touch has latest firmware. A USB connection to a Windows®
PC is required:
1. Download and install WaterLink Connect 2 Application for Windows at
http://softwarecenter.lamotte.com/. Select WaterLink Connect 2 Software
for Windows FREE Download.
2. Plug meter into the computer with the provided USB cable and launch
WaterLink Connect 2 Application from the Start Menu.
3. A prompt will appear if firmware updates are available. Select Update.
Testing and data transfer will not be possible until firmware has been
updated.
METER
1. The meter can be powered from an AC outlet, a computer or the internal battery.
2. Use the USB cable and the adapter to plug the meter into an AC outlet.
3. Use the USB cable to connect the meter to the USB port of a computer.
CHARGE THE BATTERY
1. Use the USB cable and the adapter to plug the meter into an AC outlet or use the
USB cable (included) with a car charger (not included) to charge the battery. (Anker
PowerDrive 2, DC 12/24V, 5V = 4.8A, Part Number A2310 recommended.)
2. The battery icon on the screen will show the battery status. Charge the battery until
the battery indicator is full.

FIRMWARE UPDATES

Occasionally, the firmware in the Spin Touch will require updates. A USB connection to a
Windows PC is required. To do so:
1. Visit http://softwarecenter.lamotte.com/
application for Windows.
2. Plug the Spin Touch into the computer using the included USB cable.
3. Open the WaterLink Connect 2 desktop application and wait for the update to
complete.
Once the update is complete, it is safe to close WaterLink Connect 2 and unplug the
lab. After updating the firmware, it is recommended that the LED Calibration and Angle
Calibration procedures be performed.
NOTE: When a prompt to update the firmware is received, the options Update Now or
Remind Me Later will be displayed. If Remind Me Later is chosen, the update prompt will
be displayed again in 23 hours. Or, to update the firmware at any time, open WaterLink
Connect 2, go to Settings>Service Settings>Get Updates.
PC CONNECTION
When the WaterLink Spin Touch is connected to a computer via USB, the onboard
touchscreen becomes disabled and operation of the lab is performed using the WaterLink
Connect 2 application for Windows. This application is available for free at
and download the WaterLink Connect 2
2
http://