Performance Data Sheet - Cafe CDB36 Manuel D'utilisation

PERFORMANCE DATA SHEET

SmartWater™ Filtration System— MWF Cartridge
The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the
permissible limit for water leaving the system as specified in NSF/ANSI Standard 42 and Standard 53. System tested and certified by NSF
International against NSF/ANSI Standard 42 and Standard 53 for the reduction of substances listed below.
Capacity 300 Gallons (1,135 Liters).
Substance Tested Average
for Reduction Influent
Chlorine Taste and Odor 2.0 mg/L
Nominal Particulate Class
11,333,333 pts/mL At least 10,000 particles/mL
Cyst* 101,000 cysts/L
Asbestos 133 MF/L
Atrazine 0.008 mg/L
Benzene 0.014 mg/L
Carbofuran 0.08 mg/L
Endrin 0.007 mg/L
Lead @ pH 6.5 0.148 mg/L
Lead @ pH 8.5 0.155 mg/L
Lindane 0.002 mg/L
Mercury @ pH 6.5 0.006 mg/L
Mercury @ pH 8.5 0.006 mg/L
P-Dichlorobenzene 0.223 mg/L
Tetrachloroethylene 0.014 mg/L
Toxaphene 0.017 mg/L
2, 4-D 0.192 mg/L
*Based on the use of Cryptosporidium parvum oocysts.
The following pharmaceutical reduction claims have not been certified by NSF International or the state of California.
Claims tested and verified by independent laboratory:
Contaminant Average
Reduction Influent
Atenolol 978 ng/L
Fluoxetine 907 ng/l
Ibuprofen 885 ng/L
Progesterone 1097 ng/L
Trimethoprim 415 ng/L
Application Guidelines/Water Supply Parameters
Service Flow 0.5 gpm (1.9 lpm)
Water Supply Potable Water
It is essential that the manufacturer's recommended installation, maintenance and filter replacement requirements be carried out for the product to perform as
advertised. See Installation Manual for Warranty information.
Note: While the testing was performed under standard laboratory
conditions, actual performance may vary. Contaminant reduction
testing is conducted every five years by certifying agency to
maintain certification.
Replacement Cartridge: MWF. For estimated costs of replacement
elements please visit our website at geapplianceparts.com.
WARNING
To reduce the risk associated with ingestion of contaminants:
• Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before and
after the system. Systems certified for cyst reduction may be
used on disinfected water that may contain filterable cysts.
Tested and certified by NSF International against
NSF/ANSI Standard 42 and Standard 53 in model
GE Appliances MWF for the reduction of the
claims specified on the performance data sheet.
REPLACEMENT
ELEMENT
49-1000519 Rev. 0
Contaminant Reduction Determined by NSF testing.
NSF specified
Challenge Avg %
Concentration Reduction
2.0 mg/L ± 10% 97.4%
99.9%
Minimum 50,000 cysts/L 99.99%
10 to 10 fibers/L; fibers
7 8
>99%
0.009 mg/L ± 10% 91.3%
0.015 mg/L ± 10%± 96.5%
0.08 mg/L ± 10% 74.5%
0.006 mg/L ± 10% 97.1%
0.15 mg/L ± 10% 99.3%
0.15 mg/L ± 10% 99.3%
0.002 mg/L ± 10% 96.5%
0.006 mg/L ± 10% 87.6%
0.006 mg/L ± 10% 93.2%
0.225 mg/L ± 10% 99.8%
0.015 mg/L ± 10% 96.5%
0.015 mg/L ± 10% >93.9%
0.210 mg/L ± 10% 77.7%
NSF specified
Challenge Avg %
Concentration Reduction
N/A 99.5%
N/A 99.4%
N/A 94.1%
N/A 99.5%
N/A 99.5%
Average Max Permissible
Product Water Product Water
Concentration Concentration
0.05 mg/L N/A
5,510 pts/mL N/A
1 cyst/L N/A
N/A
0.0007 mg/L 0.003 mg/L
0.0005 mg/L 0.005 mg/L
0.01 mg/L 0.04 mg/L
0.0002 mg/L 0.002 mg/L
0.001 mg/L 0.010 mg/L
0.001 mg/L 0.010 mg/L
0.00002 mg/L 0.0002 mg/L
0.0004 mg/L 0.002 mg/L
0.0007 mg/L 0.07 mg/L
0.005 mg/L 0.075 mg/L
0.0005 mg/L 0.005 mg/L
0.001 mg/L 0.003 mg/L
0.040 mg/L 0.07 mg/L
Average Max Permissible
Product Water Product Water
Concentration Concentration
5.0 ng/L N/A
5.4 ng/L N/A
52.3 ng/L N/A
5.0 ng/L N/A
2.0 ng/L N/A
Water Pressure 40-120 psi (2.8-8.2 bar)
Water Temperature 33°F-100°F (0.6°C-38°C)
NOTICE
To reduce the risk associated with property damage due to
water leakage:
• Read and follow use instructions before installation and use of
this system.
• Installation and use MUST comply with all state and local
plumbing codes.
• Do not install if water pressure exceeds 120 psi (8.2 bar). If
your water pressure exceeds 80 psi (5.5 bar), you must install a
pressure-limiting valve. Contact a plumbing professional if you
are uncertain how to check your water pressure.
• Do not install where water hammer conditions may occur. If
water hammer conditions exist you must install a water hammer
arrester. Contact a plumbing professional if you are uncertain
how to check for this condition.
• Do not install on hot water supply lines. The maximum operating
water temperature of this filter system is 100º F (38º C).
• Protect filter from freezing. Drain filter when temperatures drop
below 33ºF (0.6ºC).
• The disposable filter cartridge should be replaced every 6
months at the rated capacity, or sooner if a noticeable reduction
in flow rate occurs.
NSF Reduction NSF
Requirements Test Report
J-00137878
J-00137881
J-00100036
J-00137886
N/A J-00137910
N/A J-00137912
N/A J-00147488
N/A J-00100039
N/A J-00137914
N/A J-00137915
N/A J-00137924
N/A J-00137925
N/A J-00092355
N/A J-00137926
N/A J-00137929
N/A J-00137928
N/A J-00147489
NSF Reduction NSF
Requirements Test Report
N/A J-00121587
N/A J-00121587
N/A J-00121588
N/A J-00121589
N/A J-00121587
17