Installation; Using The Adjusters - BOXLIGHT MP-86i Manuel D'utilisation

Installation

Typical LCD Projector and Screen Installation
Use the diagram below as reference to determine the screen size and projection distance.
Screen
Screen size (inches/cm)
40/102
60/152
80/203
100/254
120/305
150/381
200/508

Using the adjusters

Use the adjusters on the bottom to adjust the projection angle.
Adjuster
1. Lift up the projector and release the adjuster lock.
2. After adjusting the projection angle, firmly lock the adjusters.
3. Rotate the adjusters for fine adjustment.
Caution
• Do not release the locks unless the projector is being held; otherwise, the projector could
overturn or the fingers could get caught and cause personal injury.
• Do not force the adjusters to rotate. This could damage the adjusters or cause the lock to fail.
• Lock the adjusters firmly. If the lock is difficult to operate, change the angle slightly and try again.
12
Top view
a
a (inches/cm)
Minimum Maximum
55/140 73/185
85/216 114/290
114/290 151/384
144/366 191/485
176/447 231/587
220/559 282/716
291/739 386/980
Front view
b
a. Distance from the LCD projector to the screen
b. Distance from the lens center to the bottom of
b (inches/cm)
the screen (a,b : +/-10%).
1/2.5
Caution
2/5
The LCD projector should normally be used
level (the legs can point upward).
2/5
Positioning the projector sideways, or with the
3/8
lens pointing upward or downward can cause the
3/8
internal temperature to rise, which could result in
a malfunction.
4/10
The projection distances shown in the diagram to
6/15
the left are for full size (800 x 600 dots).
Variable within the range of approximately 0° - 9°
Side view
Lens center
a
Side view