Regulatory Information - Neato D8 Manuel

Regulatory information

Neato Robotics, Inc.
50 Rio Robles
San Jose, CA 95134
USA
Neato Robotics Co., Ltd.
#942 Win Aoyama,
2-2-15 Minami-Aoyama,
Minato-ku.
Tokyo 107-0062
Japan
Neato B.V.
WTC Schiphol Airport, Toren D
Schiphol Boulevard 359
1118 BJ Schiphol
Netherlands
Neato Robotics Inc hereby declares that the Robot Vacuum Cleaners,
D8, D9, D10 are in compliance with the Radio Equipment Directive (RED)
2014/53/EU.
EC Declaration of Conformity
The full text of the EU declaration of conformity is available online at
the following address: www.neatorobotics.com/EC.
REACH
Neato Robotics' products are "articles" as defined in REACH Article
3(3) and do not release substances under their normal use.
The Technical Construction File is maintained at Neato Robotics
UK office.
ENGLISH
The Authorized representative located within the community is: Neato
Robotics, UK Office. The last two digits of the year the CE Mark was first
affixed to Botvac models are 14.
FCC and industry Canada compliance statment
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by Neato
Robotics could void the user's authority to operate the equipment.
RF Radiation Hazard Warning
To ensure compliance with FCC and Industry Canada RF exposure
requirements, this device must be installed in a location where the
antennas of the device will have a minimum distance of at least
20 cm from all persons. Using higher gain antennas and types of
antennas not certified for use with this product is not allowed.
The device shall not be co-located with another transmitter.
IC/ISED Radiation Exposure Statement
This product complies with the Canadian Standard RSS-102 for
portable RF exposure limits, set forth for an uncontrolled environment
and is safe for the intended operation as described in this manual.
Industry Canada Notice and Marking
The term "IC:" before the radio certification number only signifies that
Industry Canada technical specifications were met.