Installation; Before The Installation; Connection Cable; Technical Information - Electrolux EHS6940HOW Notice D'utilisation

8. INSTALLATION

WARNING!
Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Model .......................................
PNC .........................................
Serial number ...........................
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.

8.3 Connection cable

• For a single phase or two phase
connection use the following (or higher)
mains cable type: H05BB-F Tmax
90°C.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05BB-F Tmax 90°C.
Speak to your local Service Centre.

9. TECHNICAL INFORMATION

9.1 Cooking zones specification
Cooking zone
Left front
Left rear
Right front
Right rear
For optimal cooking results use cookware
not larger than the diameter of the cooking
zone.
Nominal Power (Max heat set-
ting) [W]
1500
2000
1500
2000
8.4 Building In
min.
100 mm
min.
55 mm
30 mm
480 mm
A) supplied seal
B) supplied brackets
CAUTION!
Install the appliance only on a
worktop with flat surface.
Cooking zone diameter [mm]
145
180
145
180
ENGLISH
min.
650 mm
560 mm
A
B
9