Wiring Of The Minisonic - FAURE HERMAN UltraFlux Minisonic II Manuel D'instruction

Wiring of the Minisonic

Overview of the connection compartment
Minisonic
8
Probes connection
Connection of cord no. 1 (pair of sensors no. 1) and cord no. 2 (pair of sensors no. 2)
Minisonic
Cord n° 1 - Pair of sensors n°1
Probe 1 / Upstream probe
PIN 1
Upstream probe + Upstream probe -
Probe 2 / Downstream probe
PIN 4
Downstream probe + Downstream probe -
Cord n° 2 - Pair of sensors n°2
Probe 1 / Upstream probe
PIN 1
Upstream probe + Upstream probe -
Probe 2 /Downstream probe
PIN 4
Downstream probe + Downstream probe -
Note:
There is no + or - plug for connecting the sensors.
The choice of wire (silver or gold) for the upstream sensor must be the same for the downstream sensor
Example:
If the "gold" wire of the upstream sensor is connected to "upstream sensor +", then the "gold" wire of the
downstream sensor must be connected to "downstream sensor +" Caution: The supply voltage of the measuring
probes is high (may exceed 200V): Use electrical terminals
Fitting of electrical terminals recommended
Cord n° 2 Cord n° 1
Probe 3
Probe 1
1 2 3 1 2 3
Probe 4 Probe 2
4 5 6 4 5 6
Cord 1
PIN 2 PIN 3
Upstream probe ground
PIN 5 PIN 6
Downstream probe ground
Cord 2
PIN 2 PIN 3
Upstream probe
PIN 5 PIN 6
Downstream probe ground
Upstream probe Upstream probe
Downstream probe Downstream probe
9