Bartscher IKTS 35 Mode D'emploi page 44

CAUTION!
Never place empty cookware on an induction hob.
Heating an empty pot or pan will activate the overheating protection
mechanism, an alarm will sound and the device will turn off.
The digital display will show the error message „E2".
If this happens, remove the cookware from the induction hob and leave
the device to cool for several minutes.
The device will then continue functioning as normal.
Setting power
•
Press the button
The factory-set power level of 1500 W (left hob) or 1000 W (right hob) will be
displayed on the digital display, at the left side next to the blocking button for
the given hob, and the device will come on.
By using the selection buttons
time within a range of 500 – 2000 W or 500 – 1500 W. The selected power will
be displayed on the digital display by the appropriate hob.
Power settings
left hob (500 - 2000 W)
500 W clocked
800 W clocked
1200 W
1500 W
1800 W
2000 W
NOTE!
The above settings may vary depending on the type of cookware.
Setting the temperature
If you prefer to work by setting the temperature, it can be changed using the buttons
near the temperature fields.
The pre-set temperature of „240 ° C" will be displayed (for both hobs) and the device will
come on.
(Temperature levels: 60, 80, 100, 120, 140, 160, 180, 200, 220 and 240 °C)
- 40 -
.
and
right hob (500 - 1500 W)
the settings can be changed at any
(500 W clocked)
(800 W clocked)
(1000 W)
(1200 W)
(1300 W)
(1500 W)