Hazard Sources - Bartscher IKTS 35 Mode D'emploi

•
To prevent hazards and to ensure optimum efficiency, no modifications or alterations
to the device that are not explicitly approved by the manufacturer may be
undertaken.
•
This device may only be operated in technically proper and safe condition.
•
Inspect the power cable regularly for damage. Never use the device if the cable is
damaged. If the power cable is damaged, have an authorised service center or
qualified electrician replace it.
•
The device is not designed for use with an external timer or remote control.
•
Only use the device indoors.
•
The device should not be used as a shelf or for storage of empty kitchenware.
•
The cooking surface is made from glass resistant to high temperature. In case of
damages or small cracks disconnect the device from the power supply immediately
and contact the service.

2.2 Hazard sources

WARNING!
Electric shock hazard!
To avoid the hazard results please follow the instructions below.
Do not operate the device with the damaged supply cable or plug.
In any case do not open the device housing. In case of electrical or
mechanical modifications the electric shock hazard will occur.
Do not place any objects like wire or nails in the vantilation slots
(air inlet and outlet).
Never immerse the device or plug in water or other liquids.
Never operate the device with moist hands or standing on
wet floor.
Remove the plug from its socket:
when the device is not used,
-
in case of anomalies during operation,
-
- before cleaning.
- 27 -