Bartscher IKTS 35 Mode D'emploi page 38

1. Assemble the serving trolley. Start the
assembly from fixing the shelves to the
bows. Keep in mind that the shelf with
the cutout must be installed on top.
Fix the shelves with use of delivered
socket head screws, washers, and nuts,
tightening them with hand.
2. Put the serving trolley on the side.
3. Install the bumpers above the castors and fix the
castors to the bows.
4. Put the serving trolley vertically and see if all castors
contact the floor.
5. Tighten the socket head screws with the hexagonal wrench.
Use the flat wrench to hold the nuts.
6. The counternuts allow for easy change of level of the castors.
NOTE!
The protective foil should be removed after the assembly to avois scratches.
Installation of the induction cooker
1. Put the supply cable through the
cutout in the upper shelf and install
the cooker. Pay attention to the
device stability.
- 34 -
socket head
screw
2. The lower shelves of the serving
trolley may be used for storing the
kitchen utensils.
3. Place the trolley in appropriate place
and block the castors with brakes.
nut
washer