Belden Hirschmann OZD Genius G12 Serie Manuel page 27

Based specifications and standards
The devices fulfil the following specifications and
standards:
– EN 61000-6-2:2001 Generic standards – Immunity for
industrial environments
– EN 55022:1998 + A1 2000 – Information technology
equipment – Radio disturbance characteristics
– EN 60950:1997 – Safety of Information Technology
Equipment (ITE)
– EN 60825-1 Safety of laser products
– FCC 47 CFR Part 15:2000 – Code of Federal
Regulations
– ANSI/ISA 12.12.01-2012, Nonincendive Electrical
Equipment for Use in Class I and II, Division 2 and
Class III, Division 1 and 2 Hazardous (Classified) Loca-
tions.
– C22.2 No. 142-M1987 and CSA C22.2 No. 213-M1987,
Non-incendive Control Equipment for Use in Class I,
Division 2 Hazardous Locations.
Notes on CE identification
7
The devices comply with the regulations of the
following European directive:
89/336/EEC
Council Directive on the harmonization of the legal regu-
lations of member states on electromagnetic compatibility
(amended by Directives 91/263/EEC, 92/31/EEC and
93/68/EEC).
The EU declaration of conformity is kept available for the
responsible authorities in accordance with the above-
mentioned EU directives at:
Hirschmann Automation and Control GmbH
Stuttgarter Strasse 45 – 51
72654 Neckartenzlingen
Germany
Telefon +49 (0)1805 14-1538
E-Mail HAC.Support@Belden.com
Recycling Note
,
After its use, this product has to be processed
as electronic scrap and disposed of according to
the pre vailing waste disposal regulations of your
community/district /country/state.
25
RELEVANT FOR USE IN NORTH AMERICA:
THESE DEVICES ARE OPEN-TYPE DEVICES THAT ARE
TO BE INSTALLED IN AN ENCLOSURE SUITABLE FOR
THE ENVIRONMENT.
THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I,
DIVISION 2, GROUPS A, B, C AND D OR NON-HAZAR-
DOUS LOCATIONS ONLY.
WIRING MUST BE IN ACCORDANCE WITH CLASS I,
DIVISION 2 WIRING METHODS AND IN ACCORDANCE
WITH THE AUTHORITY HAVING JURISDICTION.
FOR USE IN CLASS I DIVISION 2 HAZARDOUS
LOCATIONS REFER TO THE CONTROL DRAWING
NO. 000100622DNR ON THE NEXT PAGE.
FCC RULES
(Relevant for North America)
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference when the equipment is operated in
a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio commu-
nications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case
the user will be required to correct the interference at his
own expense.
C-Tick
Australia / New Zealand
This product meets the requirements of the
AS/NZS 3548 standard.
N1337
Version 05 07/2014