OTC OBD II Scan Tool Mode D'emploi page 10

The Tool will indicate Ready (ok), Not Ready (inc), or Not Applicable
(n/a) for each I/M Monitor. The Tool supports the following I/M Monitors:
Monitors
Misfire Monitor
Fuel System Mon
Comp Component
Catalyst Mon
Htd Catalyst
Evap System Mon
Sec Air System
A/C Refrig Mon
Oxygen Sens Mon
Oxygen Sens Htr
EGR/VVT Sys Mon
NMHC Cat Mon
NOX Treat Mon
Boost Pres Mon
Exhst Gas Sensr
PM Filter Mon
This is a complete list of I/M Monitors supported by the Tool. The number
of Monitors read by the Tool from your vehicle may vary. A diesel vehicle,
for example, does not have an Oxygen Sensor Monitor. As a result,
there will be no Oxygen Sensor Monitor status for a diesel vehicle.
Two types of I/M Monitors tests are:
‰ Since DTCs Cleared - shows status of the monitors since the
DTCs were last erased.
‰ This Drive Cycle - shows status of monitors since the start
of the current drive cycle. Refer to the vehicle service manual
for more detailed information on emission-related monitors
and their status.
9 Some vehicles do not support This Drive Cycle. If vehicle
supports both types of monitors the I/M Monitors Menu
displays.
Expanded Name
Misfire Monitor
Fuel System Monitor
Comprehensive Components Monitor
Catalyst Monitor
Heated Catalyst Monitor
Evaporative System Monitor
Secondary Air System Monitor
Air Conditioning Refrigerant Monitor
Oxygen Sensor Monitor
Oxygen Sensor Heater Monitor
Exhaust Gas Recirculation or Variable Valve Timing Monitor
Non-Methane Hydrocarbon Catalyst
Nitrogen Oxide Treatment
Boost Pressure
Exhaust Gas Sensor
Particulate Matter Filter
10