Numark NS6II Guide D'utilisation page 16

Rear Panel
3
1
2 4
1. Power Switch: Turns NS6II on and off. Turn on NS6II after all input devices have been
connected and before you turn on amplifiers. Turn off amplifiers before you turn off NS6II.
2. Power In: Use the included power adapter (12 V DC, 2 A, center-positive) to connect
NS6II to a power outlet. While the power is switched off, plug the cable into NS6II first, and
then plug the cable into a power outlet.
3. Cable Restraint: You can secure cables to this restraint to help avoid disconnecting them
accidentally.
4. USB Port 1/2: Use a standard USB cable (included) to connect each USB port to an
available USB port on a computer. These 2 ports allow you to control audio from 2
computers at the same time, which allow for seamless transitions while switching from one
DJ to another.
To set a channel to control your computer, set its Input Selector to PC, and set its USB
selector to the desired port (1 or 2).
5. Line/Phono Inputs (RCA): Connect your audio sources to these inputs. These inputs can
accept both line and phono-level signals.
6. Line/Phono Switch: Flip this switch to the appropriate position, depending on the device
connected to the Line/Phono Inputs. If you are using phono-level turntables, set this
switch to Phono to provide the additional amplification needed for phono-level signals. If
using a line-level device, such as a CD player or sampler, set this switch to Line.
7. Grounding Terminal: If using phono-level turntables with a grounding wire, connect the
grounding wire to these terminals. If you experience a low "hum" or "buzz", this could
mean that your turntables are not grounded.
Note: Some turntables have a grounding wire built into the RCA connection and, therefore,
nothing needs to be connected to the grounding terminal.
8. Mic Inputs (1/4"): Connect 1/4" (6.35 mm) microphones to these inputs. Microphone
controls are located on the front panel. The inputs' audio signals are routed directly to the
Program Mix and Cue Mix.
9. Booth Output (RCA): Use standard RCA cables to connect this output to a booth
monitoring system. The level of this output is controlled by the Booth knob on the top
panel.
10. Master Output (RCA): Use standard RCA cables to connect this output to a speaker or
amplifier system. The level of this output is controlled by the Master knob on the top panel.
11. Master Output (XLR): Connect this low-impedance XLR output to a PA system or
powered monitors. The level of this output is controlled with the Master knob on the top
panel.
16
7
6 5 5 6 8 10
9
11