Numark NS6II Guide D'utilisation page 10

29. Auto / Roll: This Pad Mode button puts the pads in two modes: Auto-Loop Mode and
Loop Roll Mode. When the button is unlit, the first press will always select Auto-Loop
Mode.
Note: The pad layouts here match the software's default Auto-Loop time division layout. If
you shift the range of time divisions displayed in the software, the pad layout will change
to match it.
• Auto-Loop Mode: Each pad triggers or releases an Auto-Loop of a different length.
Press and hold Shift and then press the Parameter < or Parameter > button to shift
the Auto-Loop backward or forward.
• Loop Roll Mode: Each pad triggers a momentary Loop Roll. Press the Parameter < or
Parameter > button to change the Loop Roll's time division.
30. Loop: This Pad Mode button switches the pads between two banks of saved loops and
Manual Loop controls. When the button is unlit, the first press will always select the first
bank.
•
Saved Loop Mode: Pads 1-4 (the top row) return the track to one of your saved loops.
You create and save a loop using Pads 5-8 (the bottom row). The pad layouts for the
two banks are identical.
o To create a loop, press Pad 5 to set the Loop In Point, and then press Pad 6 to
set the Loop Out Point and trigger the loop.
o To save a loop, while a loop is active, press any one of Pads 1-4 (the top row) that
does not have a loop assigned to it. You can do this regardless of how the loop
was created (Saved Loop Mode, Auto-Loop Mode, Loop Roll Mode, etc.).
o To trigger a saved loop, press any one of Pads 1-4 (the top row) that has a loop
saved to it. Press Pad 7 to activate or deactivate the loop. Press Pad 8 to return
the track to the last triggered loop and reactivate it ("reloop").
o To delete a saved loop, press and hold Shift and then press the corresponding
pad (of Pads 1-4).
o To halve or double the length of a loop, press the Parameter < or Parameter >
button.
o To shift a loop backward or forward, press and hold Shift and then press the
Parameter < or Parameter > button.
10
1/4-beat
1/8-beat
2-beat 4-beat
Loop 2
Loop 1
Set Loop In Set Loop Out
1/2-beat 1-beat
8-beat 16-beat
Loop 3 Loop 4
Loop On/Off Reloop