Télécharger Imprimer la page

Monacor International img Stage Line TXS-820LT Manuel D'instructions page 2

Publicité

Les langues disponibles

Les langues disponibles

TXS-820LT
TXS-822LT
Order No. 24.0930
Order No. 24.0920
Pocket Transmitter with
GB
Tie-clip Microphone
863.05 / 864.80 MHz
Please read these instructions carefully prior to
setting the unit into operation and keep them for
later use.
1 Applications
In combination with a receiver, the transmitter
TXS-8..LT makes up a wireless microphone sys-
tem. This system allows wireless transmission of
music and speech from the microphone to the
receiver. The range is approx. 30 m and de-
pends on local conditions.
It is possible to combine e. g. the following
receivers from the "img Stage Line" range with
the TXS-8..LT transmitters:
suitable for
Type
TXS-820LT
TXS-800
1-channel receiver
TXS-840
2-channel receiver
TXS-860
1.1 Approval
Conformity and Approval
Herewith, MONACOR INTERNATIONAL de-
clare that the units TXS-820LT and TXS-822LT
are in accordance with the basic re quirements
and the other relevant regulations of the direc-
tive 1999 / 5 / EC. The units are licence-free and
generally approved for operation in EU and
EFTA countries.
2 Safety Notes
G
The transmitter and the microphone are suit-
able for indoor use only. Protect them against
dripping water and splash water, high air
humidity, and heat (admissible ambient tem-
perature range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth, never
use chemicals or water.
POWER
VOL.
ON OFF
1
2
3
4 5
G
No guarantee claims for the transmitter or the
microphone and no liability for any resulting
personal damage or material damage will be
accepted if the transmitter or the microphone
is used for other purposes than originally
intended, if it is not correctly connected, oper-
ated, or not repaired in an expert way.
If the transmitter and the mikrophone
are to be put out of operation defini-
tively, take them to a local recycling
plant for a disposal which is not harm-
ful to the environment.
Dead batteries or defective rechargeable bat-
teries do not belong in the household rubbish,
always take them to a special waste disposal
(e. g. collective container at your retailer).
3 Setting into Operation
suitable for
TXS-822LT
1) Open the battery compartment. Insert a 9 V
battery with the positive and negative poles as
TXS-802
indicated in the battery compartment (fig. 2).
TXS-842
2) Fasten the transmitter on your belt by means
TXS-860
of the clip (3). If required, turn the clip by 90°
(locks into place). For this purpose, slightly
release the screw on the clip and then
retighten it.
3) Fasten the tie-clip microphone (9) to your
clothes. Connect the microphone to the jack
(5) on the transmitter. The microphone plug
(8) can be secured from getting loose by
screwing the knurled nut (7) of the plug on the
jack.
4) Adjust the input sensitivity with the switch
SENS (6) in the batttery compartment:
pos. 1 for connecting an electric guitar or
another signal source with an output
level of 600 mV max.
pos. 2 for connecting a dynamic micro-
phone
pos. 3 for the supplied tie-clip microphone
or for another electret microphone or
capacitor microphone; there is an
operating voltage of 5 V at the con-
tact tip of the microphone plug (8)
Œ
®
MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany
©
Copyright
by MONACOR INTERNATIONAL. All rights reserved.
5) Switch on the transmitter with the sliding
switch POWER (2). The red LED (1) lights up
as a power indicator. If it fails to light up or if
it only shows a dim light, the battery is ex -
hausted and must be replaced.
position ON. In mid-position, the transmitter
is mute, i. e. it is switched on but no sound is
transmitted.
6) Speak into the microphone. Advance the con-
trol VOL (4) to such an extent that the re -
ceiver is not overloaded, i. e. that the trans-
mission signal is not distorted.
7) Remember to switch off the transmitter after
operation. If it is not used for a longer period
(e. g. more than a week), the battery should be
removed to prevent any damage to the trans-
mitter caused by potential battery leakage.
4 Specifications
Carrier frequency
TXS-820LT: . . . . . . 863.05 MHz
TXS-822LT: . . . . . . 864.80 MHz
Transmitting power: . . < 5 mW (EIRP)
Frequency stability: . . ±0.005 %/25 °C,
Modulation: . . . . . . . . . FM, ±40 kHz
Audio frequency range: 50 to 15 000 Hz
Range: . . . . . . . . . . . . approx. 30 m
Ambient temperature: . 0 – 40 °C
Power supply: . . . . . . . 9 V battery
Dimensions: . . . . . . . . 66 × 108 × 35 mm
Weight: . . . . . . . . . . . . 95 g
Subject to technical change.
9V

6
Slide the switch POWER to the left stop to
quartz-controlled
7 8
9
A-0462.99.04.07.2011
Ž

Publicité

loading

Ce manuel est également adapté pour:

Img stage line txs-822lt24.092024.0930