Quick Tips On Sending A Job To The Stacker - Oce VARIOPRINT 5000 Stacker Manuel Opérateur

QUICK TIPS ON SENDING A JOB TO THE STACKER

1) On host printer: Ensure the personality profile is set for the type of job you to run.
2) Switch on the stacker. Ensure that the stacker main switch is on (behind narrow cover on
right side). The Green switch will illuminate when power is on.
3) Make sure the Cart is present and the Stack Securing Bar is placed in its holder.
4) Program the stacker at the keyboard:
a) Bypass mode (Upper Icon): Bypass this stacker. Will not stack at all in this stacker
b) Manual Stacking Mode (Center Icon): Stacks in this stacker unit only and shuts down
c) Auto Mode (Lower Icon): Used with multiple stackers. When one stacker unit is full,
d) Select Offset or straight stacks: If Offset Mode is selected, every other set is offset
5) Press the green start button. When the green LED is flashing lit, the stacker unit is ready to
accept sheets.
Operator Manual
Page 9 - 25
(must have another device downstream).
when full.
sheets will be automatically fed to the next stacker unit.
Initial issue: 01/03
Latest revision: