Keyboard Description; Keyboard Buttons; Keyboard Status Leds - Oce VARIOPRINT 5000 Stacker Manuel Opérateur

1. Keyboard buttons

1. Start button - Pressing the start button puts the stacker in the standby mode.
The elevator must be in the up position and the red stop LED (8) must be
steady on before the start button can be activated. The elevator LED (9) will
flash indicating to bring the elevator to the up position. The red stop LED (8)
goes off and the green LED (7) is flashing.
The signal from the printer turns on the main drive motor. The Stacker is in
running mode. The green led goes on.
2. Stop Button - Pressing the stop button puts the stacker in the stopped mode. The red stop
LED (8) goes steady on, the paper transport motor stops.
3. Elevator Up Button - Pressing the Elevator Up Button while in the stopped mode raises the
4. Elevator Down Button - Pressing the Elevator Down Button lowers the elevator to ground
5. Offset Mode Button - Pressing the Offset Mode Button while in the stopped mode will
6. Stacking Mode Button - Pressing the Stacking Mode Button while in the stopped mode will

2. Keyboard status LEDs

7. Start button LED
8. Stop button LED
9. Down button LED
10. Up button LED
11. Offset / Straight stack LEDs
12. Bypass / Manual stacking / Auto stacking LEDs
Operator Manual
Page 9 - 15

KEYBOARD DESCRIPTION

elevator to the top. The yellow elevator Up LED (10) is steady on
while elevator is going up.
unless the button is pressed again. In that case, it will stop lowering.
The yellow elevator Down LED (9) is steady on while elevator is
going down.
toggle between the Bypass Mode, Manual Stacking, and Auto
Stacking.
That selection can only be made in stopped mode (i.e. when the red
LED (8) of the ''Stop'' button is on).
toggle between straight stacking and offset stacking. You must be
in the manual stacking or the auto stacking mode for this feature
to be active.
Initial issue: 01/03
Latest revision: