Descaling Of The Tip; Cleaning Of The Filter; Change Of Batteries In The Remote Control; Stop Due To Prolonged Absence - Roca In-Wash In-Tank A803094001 Mode D'emploi

❚

4.3 DESCALING OF THE TIP

The holes in the tip may get blocked up due to limescale. Should this occur, the water flow diminishes and the
lights on the equipment blink 3 times, signaling that the tip must be descaled.
To descale it, immerse it in a liquid anti-limescale available in the market. Rinse and reinstall.
❚

4.4 CLEANING OF THE FILTER

We recommend carrying out the maintenance of the filter once every year to ensure a correct functioning of the device.
1
1. Close the shut-off valve.
2. Remove the filter.
3. Clean the filter.
4. Replace the filter in its position ensuring it is properly installed and reopen the shut-off valve.
❚

4.5 CHANGE OF BATTERIES IN THE REMOTE CONTROL

The batteries needed for the remote control are two button batteries type CR-2032.
We recommend not mixing new and used batteries or batteries from different brands.
The remote control indicates that the batteries are running low with a quick blinking of the leds after a use. They should be replaced then.
❚

4.6 STOP DUE TO PROLONGED ABSENCE

If a long time elapses without using the In-Wash we recommend switching to Stand-By mode. See section 3.6
24
2
CR 2032 (x2)
Anti-cal
Anti-limescale
CR 2032 (x1)
1h
3