Niko 360-45010 Mode D'emploi page 39

360-45010
390-40011
Single-pole switch 170-01100
Youy can connect an energy-saving switch (loadshedding --> see '4.2 ADJUSTMENT') to the daylight
control module in order to only switch on the lighting at a lower level of daylight.
4-fold push button with feedback LEDs 170-40100
For evry application (see 4.4), you can connect a 4-fold push button with feedback LEDs. Only 2 of
the 4 push buttons with feedback are used, because the module can only switch the lighting:
- Auto (with feedback): The system goes to automatic mode, the lighting is daylight controlled
according to the settings of the application.
- I/O (with feedback): 'on-off'. The system is set to manual mode. You can switch the lighting on
or off by pressing the push button. If the lighting is switched on, it is NOT daylight controlled,
but is switched on in all areas.
3.4 Applications
The daylight control module is provided with a number of preprogrammed applications as a standard
(fig.3) For how to select an application, see 'Quickguide'.
Application 00.01 (fabric setting):
Automatic on/off via motion sensor (fig.4a)
If the motion sensor detects movement, the 3-channel on/off daylight control module is activated.
The light is controlled in 3 channels in accordance with the set parameters. If the min. daylight
level for a channel (zone) is reached, the light is switched off. If the motion sensor(s) do not detect
movement, the light automatically switches off after a preset time. For use in e.g. corridors, halls
(factory setting).
Application 01.01:
On/off via time switch 420-00200 + 1XX-78200 (fig.4b)
The 3-channel on/off daylight control module is switched on and off via an external time switch. The
light is controlled in 3 channels in accordance with the set parameters. If the min. daylight level for
a channel (zone) is reached, the light is switched off. For use in e.g. exhibition premises
EN 39